Yamaha Stryker Licence Plate Kit w/LED Brake Light by Low and Mean

Star Stryker LED brake light and license plate kit Clean up the rear fender of your Star Stryker with this LED brake turn license plate kit. This product is intended to replace the cluster on the back of the Star Stryker stock rear fender. The LED follows the rear design of the Star Stryker rear fender which gives your ride a clean custom look. The brightness of the red LED is more than enough at night and it works very good during the day. The kit comes with a red LED brake light with built in turn signals, you have the choice of three different color tubes to hold the red LED. Also included is a license plate frame and a light to shine on your license plate, the kit is finished off with hardware and instructions. What you need to know: The complete rear plastic section on your stock rear fender will be replaced. You will have to wire this kit into the stock wire harness. Please see wire diagram below. Do to the shape of the rear fender the turn signals are not as visible as stock. We suggest adding the extra turn signal LED's for the best results. LED only come's in red, but you can change the color of the outer tube. There is the function to run this in dual mode, as running lights and brake / turning. The turn signals will flash fast with out a equalizer module. The extra LED option comes as two 3.4" LED stripes that can attach to either side of the license plate holder (SEE IMAGE ABOVE) or maybe another place on the back of the motorcycle. These lights can be used for running, turning, or brake. They are red LED lights with your choice of color tubing.